The MAC address is now being displayed at the HWaddr, ether or lladdr line.Open a new terminal with root privileges or run it as a superuser using sudo.Choose the Hardware tab, under which you will see the MAC address of your ethernet card.All we need is to open the terminal then type ifconfig -a in the prompt. Click Advanced in the lower right corner. The best Linux command to find MAC address is using ifconfig command. In the left-hand pane, select Ethernet.Scroll down to the Ethernet network adapter and look for the values next to Physical Address, which is your MAC address.Your network configurations will display. If you have iproute2 utilities installed, you may prefer to use the ip command, as follows: /etc/init.d/network stop: ip link set eth0 address 02:01:02:03. Type in ipconfig /all and press Enter.Click on the Start button, type cmd and press Enter.This manual uses a consistent style of writing: references to text and buttons on screens are printed in italics, information that you have to enter yourself is printed in bold.This manual is written for Windows, MacOS and Linux.Students or guests (with a UT guest account) can register MAC addresses at the Selfservice Registration Portal for Network Devices (SRN) to access the wired UT network. Click Start Programs Command Prompt In the MS-DOS Command Prompt Window, type ipconfig/all Look for the section describing the Ethernet Adapter settings. IntroductionĪ MAC address is the physical address of a network card.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |